Our Privacy/Cookie Policy contains detailed information about the types of cookies & related technology on our site, and some ways to opt out. By using the site, you agree to the uses of cookies and other technology as outlined in our Policy, and to our Terms of Use.

Close

How to Build a Whelping Box for German Shepherds

| Updated September 26, 2017

Things You'll Need

  • 1 full sheet of 1-inch thick plywood board (48 inches by 96 inches)

  • 4 sections of 2-by-1 wood strips (24 inches long)

  • 4 sections of 22-mm wooden dowel (48 inches long)

  • 1 1/2-inch wood screws

  • Circular saw

  • Electric drill

  • Towels, newspaper, or other padding

  • Heat lamp

Whelping boxes serve as a safe and protected place for mother dogs to birth and care for their puppies. The box keeps the puppies comfortable and contained, while allowing the mother to come and go as needed. German shepherds require a large whelping box measuring at least 48 inches on each side. Such a box can be easily constructed using sheets of plywood from a home supply store.

Use a circular saw to cut a full-size sheet of plywood (48 inches by 96 inches) into four sections. One smaller section should measure 12 inches by 48 inches, while the three larger sections should each measure 24 inches by 48 inches.

Lay out two of the larger sections of plywood (24-by-48), which will become the sides of the whelping box. Using 1 1/2-inch wood screws, attach a 2-by-1 wood strip to each 24-inch side. These strips will provide extra support when you connect the four sides of the box.

Attach the taller back and side panels (24-by-48) to the shorter front panel (12-by-48), drilling 1 1/2-inch wood screws through the outside of the side panels into the bracing wood strips on the front and back panels. Use two or three screws on each side, and make sure that no sharp tips are protruding into the box. Your four sections of plywood should now form the frame of the whelping box. The lower wall of the box will allow the mother dog to step in and out.

Install a "puppy rail" around the inside of the box to prevent the puppies from being crushed by their mother's weight. Use 1 1/2-inch wood screws to attach sections of wooden dowel on each side of the box, about 6 inches above the floor.

Line the floor of the whelping box with materials that will provide cushioning for the puppies while being easy to remove and clean. A tarp covered by towels or layers of newspaper works well.

Position in a warm, quiet area where the mother dog will not be disturbed. If needed, set up a heat lamp above the box to maintain a temperature between 70 and 85 degrees Fahrenheit.