How to Program a Pet Stop Collar

The Pet Stop fence system has a GentleSteps training program to increase stimulation levels automatically while training your pet to stay in his boundaries. You can change the stimulation level on your pet's collar to a higher or lower setting to suit your training needs.

Step One

Remove the Pet Stop collar from your dog. Walk to the area where the transmitter is mounted on a wall.

Step Two

Press and hold the center "Set" button on the transmitter. The current signal length will start flashing in the LED display to the left of the transmitter. After 3 seconds, a flashing "98" will show in the display. Immediately release the "Set" button.

Step Three

Hold your dog's collar in one hand without touching the probes on the front of it. Move it toward the transmitter so it is 2 to 6 inches from the transmitter.

Tips

  • The low battery light will flash on the collar when it's time to recharge.

Step Four

Push the top button pointing upward to increase the stimulation level by one level or press the bottom button pointing downward to decrease the stimulation level by one.

Tips

  • The receiver collars beeps twice for an increase or once for a level decrease.

Step Five

The flashing "98" on the displays stops for two seconds, then resumes flashing so you can make further adjustments to the stimulation level one at a time.

Step Six

Press the center "Set" button on the transmitter to save your new settings.

Author

Mary Lougee has been writing for over 10 years. She holds a Bachelor's Degree with a major in Management and a double minor in accounting and computer science. She loves writing about careers for busy families as well as family oriented planning, meals and activities for all ages.

See More Animals